Harting Connectors

Harting Housings   –   HAN A – HAN E

Wilmod Harting BFor the electrical connection from our infrared systems we use almost always Harting connectors.
The great advantage of original Harting is the high quality of the connectors, especially in relatively warm areas.
By high temperatures it is very important that the connectors are mounted only in cold areas below 100°C.
The material is grey powder-coated  zinc die-cast for temperatures up to 125°C maximum.

For more information see PDF below :
Wilmod Infraredsystems Harting Housings

 

Harting Inserts   –  HAN A

Wilmod Harting AThe Harting HAN A are connectors with relatively small dimensions.
These connectors are available in screw terminals and special crimp contacts for cables up to 2,5 mm² what means maximum 16 Ampére by 230 VAC.
For the connection of the Elstein pilot heater, with the internal thermoelement NiCr-Ni, a special contact is not necessary.
By the high temperatures by infraredsystems it is very important that the inserts are mounted only in cold areas below 100°C.

For more information see PDF below :
Wilmod Infraredsystems Harting Inserts HAN A

 

Harting Inserts  –  HAN E

Wilmod Harting EThe Harting HAN E are connectors for the bigger HAN-B housings.
This connectors are available in screw terminals and special crimp contacts for cables up to 2,5 mm² what means maximum 16 Ampére by 230 VAC.
For the connection of the Elstein pilot heater, with the internal thermoelement NiCr-Ni, a special contact is not necessary.
By the high temperatures by infraredsystems it is very important that the inserts are mounted only in cold areas below 100°C.

For more information see PDF below :
Wilmod Infraredsystems Harting Inserts HAN E

 

 These products are only supplied together with a complete Infrared-system.